North Star Snath–Early Prototype

An initial proof of concept of the North Star snath. The snath is produced in two parts, and joined by an aluminum elbow. The halves in this case were both the same, but were technically both the upper half, as that was the component I received samples for. This resulted in too strong of a bend in the neck of the lower end, but the production version will have less severe of a curve.

The halves come overly long on purpose, allowing the user to trim them down to desired length. They can then be rotated in the aluminum coupling, allowing the snath to “shapeshift” to best adapt to the user’s preference before being drilled and bolted in its final position. This has the benefit of allowing for a truly one-size-fits-all scalable stemless snath, and allows the snath to pack down for transport or shipping. Note the strong lateral bend of the upper half. This both places the hand in a very ergonomic position, but the end can be used as a grip in its own right when lifting the lay of the blade while mowing, as circumstances sometimes dictate.

NorthStarSnathPrototype_01

NorthStarSnathPrototype_02

NorthStarSnathPrototype_03

NorthStarSnathPrototype_04

NorthStarSnathPrototype_05

NorthStarSnathPrototype_06

NorthStarSnathPrototype_07

NorthStarSnathPrototype_08

NorthStarSnathPrototype_09

NorthStarSnathPrototype_10

Leave a Reply

Your email address will not be published.